Engineering general.
After building a satellite antenna, I was able to receive and decode the weather maps sent by three US-based legacy satellites operated by the National Oceanic and Atmospheric Administration (NOAA). Hardware As mentioned, I used my own antenna. To get the signal into my PC, I used the excellent and low-cost RTL-SDR stick V3 by RTL-SDR.com. My base station consisted… Read More →
During my adventures with SDR (software-defined radio), the need for a proper QFH antenna arose. This type of antenna is used to receive signals that are circularly polarized, such as APT weather maps sent by the NOAA satellites. I used a PVC pipe and a standard shielded coax cable from the local hardware store, and a copper tube meant for… Read More →
The laser cutter is finally ready for testing! After securing the aluminium base plate (before that I had used carton) I powered up the system and sent my first gcode. Improving the Y Carriage Unfortunately, the lasered lines were rather wobbly. This was because the y carriage was only supported by one shaft. So, I ordered more parts. From Steplab:… Read More →
A few years ago, in 2017, I attended a rather large music festival. Apart from the music and general camping experience, one thing particularly got stuck in my mind: Someone wearing a beer crate as a backpack. While one could argue this not being an unusual sight at a music festival, the thing that impressed me as a maker were… Read More →
After completing the machnical construction of the laser cutter, it was time for the control circuit. I used a perfboard PSB and soldered headers for the Arduino and stepper motor drivers to it. On the bottom, I connected everything up. The limit switches needed some simple debouncing and smoothing on their signals, because the cables were so long and the… Read More →
After designing my laser cutter, the next step was to order the parts and assemble the machine. Because Actobotics parts are made and sold from USA, they are hard to come by in Europe (unless you want to pay high import taxes and shipping). In the end, I found an Italian shop (steplab.net / servocity.eu) which sold pretty much everything… Read More →
In 2016, I built a CNC laser cutter / engraver. I always wanted to document the whole process, but never got around to do so – until now. Enjoy a multi-part series on how my build went! Before I start, a word of warning: Lasers can be very dangerous to your health, eyes and general envoirement if misused. Please make… Read More →
